BB-50  BB-200  BB-300H  BB-500H


BIO BIDET™ SEATS

Clean Washing with Water!
Wiping with Dry Paper is not good enough!
 

What you have:

Flexible Hoses 7/8"x3/8" 1/2"x3/8"	(2) Adapters with emergency shut valve	10' White tube	(3) Rubber seal	(2) 1/2" Converter

What you need:

Teflon Tape	Screw Driver	Wrench
Cutter	Compression Fitting	Velcro Tape (optional)

First things first. Locate hot water source and make sure supplied 10 feet of white tube is enough to connect both hot and cold water to BB-200. Should you need extra length of tube, contact customer service or distributor in you area for immediate supply. Compression fitting is not standard supply. Be sure to have it before cutting pipe.
	1. Shut off the water valve. 2. Measure and cut copper pipe using cutter. 3. Unscrew and detach bolt. 4. Apply bolt first, then slide compression fitting. 5. Slide down and fit it to top thread of adapter. (copper pipe must be straight to thread)

6. Insert packing into bottom of adapter as illustrated, then tighten adapter to main water valve. Avoid having tube inlet addressed directly to top of water valve to turn it back on freely. You can now close emergency shut off valve and turn on main water valve to test if there is any leak.

7. Insert one end of the white tube into adapter inlet with nut as shown, the insert the other end to BB-200 hot water inlet. Use Velcro tape to secure white tube to edge of wall. This will prevent accidental unplugging tube and tube from hanging. 8. If you have a flexible metal hoes instead of copper pipe, simply substitute it with supplied flexible hose with packing inserted.

Congratulations! You are ready to use the Bio-Bidet for the first time. IT IS VERY IMPORTANT THAT YOU USE "NOZZLE CLEANING" EVERY TIME YOU USE BB-200. IT WILL: 1. PREVENT ACCIDENTAL NOZZLE CLOGGING. 2. PREVENT TOILET CLOGGING. 3. IT WILL BRING UP ENOUGH HOT WATER TO PROVIDE YOU WARM WATER WHEN YOU ARE READY TO CLEAN YOURSELF. To use it, simply pull it up all the way residual cold water is drained and warm water starts to run through. You must push it down before adjusting water pressure.

Final Assembled Figure