BB-50  BB-200  BB-300H  BB-500H


BIO BIDET™ SEATS

Clean Washing with Water!
Wiping with Dry Paper is not good enough!

What you have:

(2) Flexible Hose	Adapter	Conversion Nut	Packing

   What you need:

Teflon Tape	Screw Driver	Wrench

PREPARATION 1. Remove the existing toilet seat. To access screw, locate the lid at the end of the seat and push it upward with a sharp object. Take out seat by loosening screw and holding bolt from bottom. 2. Turn off the main water valve. 3. Take out exiting water pipe. Loosen fill valve just below the water tank and compression nut from control valve. Then take out water pipe by tapping fill valve. 4. Flush down all the remaining water in water tank.

ACTUAL INSTALLATION 1. Be sure to shut off main valve. 2. Use the supplied hose to connect the body joint of the main unit to the branching valve. Tighten the coupling nuts at the body joint and the branch outlet. 3. Be sure not to over tighten flexible hose at flush tank end. Use only hand pressure. 4. Using Teflon tape is suggested and recommended. 5. Shield the nozzle with your hand to protect the water from spraying too far during the trial operation. 6. Press the CLEANSING button to test the water stream.

CLEANING THE STRAINER The unit will not operate properly if the strainer is clogged. Be sure to clean the strainer. 1. Close the shutoff valve. 2. Flush the toilet to empty the flush tank. 3. Unscrew the nut. 4. Clean the strainer using a small brush. 5. Re-screw the nut. 6. Open the shutoff valve.