BB-50  BB-200  BB-300H  BB-500H


BIO BIDET™ SEATS

Clean Washing with Water!
Wiping with Dry Paper is not good enough!

What you have:

Flexible Hose Adapter 1/2" Conversion Packing   What you need: Teflon Tape Screw Driver   Wrench PREPARATION 1. Remove the existing toilet seat. To access screw, locate the lid at the end of the seat and push it upward with a sharp object. Take out seat by loosening screw and holding bolt from bottom. 2. Turn off the main water valve. 3. Take out exiting water pipe. Loosen fill valve just below the water tank and compression nut from control valve. Then take out water pipe by tapping fill valve. 4. Flush down all the remaining water in water tank. ACTUAL INSTALLATION 1. Connect bolt of adapter to the hexagonal nut of flexible hose. 2. Insert plastic packing into bottom of adapter as illustrated. 3. Connect 3/8" compression to the water valve. Reminder: Connect 7/8" fill valve to water tank later to prevent the hose from twisting. (It will lower water pressure) 4. Insert the tube of the Bio-Bidet into the adapter with nut as shown, then tighten it. When tightening adapter, try to avoid having the fitting bolt addressed directly to top of water valve. This will let you turn valve back on freely later. 5. Now you may connect 7/8" fill valve to water tank. Use only hand pressure to tighten it. 6. Adjust sliding seat hook coupling with toilet seat at desired position. 7. Place toilet cover on top of Bio-Bidet. 8. hold nut from the bottom while turning screw from top. 9. Push down and lock screw lid.